佰利乐Jet target high pressure cleaning machine plate distance associated with the water jet impact force, under different pressure and flow conditions, there exists an optimal target distance, and in the target range, it will be the largest water jet impact force. The following analysis of the jet distance were 120mm, 150mm, 200mm, 300mm, water jet cover area and water jet impact force changes, the schematic diagram and the data are as follows:
佰利乐Water jet coverage area
The jet distance /mm covering /mm ² area change area than the water jet impact force change ratio
佰利乐When the nozzle is determined, the jet distance is only covered area change jet variables, test results show that, if the jet distance doubled, then jet coverage area will increase 4 times, but the water jet impact force is only the original 1/4; if the jet distance is reduced by half, then jet coverage area is only the original 1/4, but the water jet impact force is 4 times of the original, so the jet target distance is also very important to reasonably determine. In the design of the jet distance, jet to target spacing increases, it is necessary to consider the decrease of water jet impact force, but also consider the jet distance decreases makes a single nozzle coverage area is reduced, increasing the coverage width need to bring the same number of nozzles.
